Differences

This shows you the differences between two versions of the page.

--- config_manager [2019/02/22 00:14]
sq3plx
+++ config_manager [2019/02/22 00:16]
sq3plx
@@ Line 49: / Line 49: @@
 This selects a type of digital thermometer connected to rear panel THERMO input and it allows to correctly compute the temperature based on binary measurements.
+After making changes we can restart the Direwolf daemon with following commands:
+<code>
+root@nanopiduo:~# service ulari-manager stop
+root@nanopiduo:~# service ulari-manager start
+</code>
+or restart whole ULARI Radio Interface with:
+<code>
+root@nanopiduo:~# reboot
+</code>
 === Data gathered by ulari-manager ===
 ulari-manager reads sensor data from Atmega microcontroller and stores them in temporary files:
-  * /tmp/exttemp - THERMO input temperature measurement in binary format,
+  * /tmp/ulari-exttemp - THERMO input temperature measurement in binary format,
-  * /tmp/exttemo-c - THERMO temperature converted to Celsius degrees based on number of bits defined in THERMOBITS parameter,
+  * /tmp/ulari-exttemp-c - THERMO temperature converted to Celsius degrees based on number of bits defined in THERMOBITS parameter,
-  * /tmp/vdet - input voltage in mV.
+  * /tmp/ulari-vdet - input voltage in mV.
+Above files are generated by ulari-manager when run and are updated every 1 second.

Ultimate Linux Amateur Radio Interface