User Tools

Site Tools


software_vhf7w

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
Last revision Both sides next revision
software_vhf7w [2019/04/15 23:29]
sq3plx created
software_vhf7w [2019/04/24 01:30]
sq3plx
Line 1: Line 1:
 ====== ULARI Transceiver VHF 7W Software ====== ====== ULARI Transceiver VHF 7W Software ======
 +
 +Our main purpose is to use the device as an APRS station, digipeater, and I-Gate. For this function we are going to use an [[https://​www.armbian.com/​|Armbian Linux distribution]] and a really nice Open Source [[https://​github.com/​wb2osz/​direwolf|Direwolf]] application written by WB2OSZ. Direwolf is an advanced 300/​1200/​9600 baud APRS packet modem which uses software DSP routines for packet decoding.
 +
 +{{:​ulari_interface_05l.jpg?​300| APRS packets received by ULARI}}
 +
 +=== ULARI Transceiver VHF 7W Linux image files ===
 +
 +Image files for ULARI can be found here: [[image_vhf7w|ULARI Transceiver VHF 7W Linux image files]].
 +
 +=== Decompressing ULARI Transceiver VHF 7W Linux image ===
 +
 +Linux image files are compressed with [[http://​www.7-zip.org/​|7-ZIP]] archive software so you need to decompress it to get a full .img file containing the uncompressed image. This image must be decompressed before writing to SD card or it will not work.
 +
 +=== Writing software to SD card ===
 +
 +>If you bought the device from me, then the pre-programmed card should be already inserted to "SD CARD" slot and you can skip this chapter.
 +
 +Linux image file can be copied to SD card using your PC card reader as many times as you like. This means that you can play and experiment with your system as much as you want and get back to a clean installation if you have any problems.
 +
 +For writing a Linux image to SD card we will use a [[https://​sourceforge.net/​projects/​win32diskimager/​|Win32 Disk Imager]] which is a free image writer for Windows. All you need to do is to select a proper image file and SD card drive letter.
 +
 +{{:​win32diskimager.jpg?​direct&​300|Writing Linux image using Win32 Disk Imager}}
 +
 +After writing the image to SD, you can use a "​Verify"​ button to make sure that everything was written correctly. Then put the SD card into ULARI SD card slot and then connector power to the device.
 +
 +>Do not switch SD card when ULARI is powered or you can damage both your card and microprocessor module.
software_vhf7w.txt ยท Last modified: 2021/05/16 00:53 by sq3plx